Microplex SOLID F40 - Page 100

100 Operator Maintenance
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
!
4. Place the charger onto a clean and level worktop.
5. Using the blower brush, remove paper dust and other
unwanted particles.
6. Then clean the wires using a wire cleaning tool. After having
finished this procedure the wires should be completely
smooth.
7. Replace the charger in its original position and tighten the
knob screw.
8. Close the waste toner recovery unit.
Make sure the bar has engaged.
9. Close the front cover of the printer.