Microplex SOLID F40 - Page 120

120 Operator Maintenance
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
Make sure the transfer-/separator charger is in its down position to
avoid damaging the photoreceptor drum.
8. To determine the position of the transfer charger (C3) please
go on like this:
- Turn the transfer elevator drive shaft clockwise.
Should the charger start to move up it is already in the
down position.
-
Is the charger moving down, turn the drive shaft until it is
in the deepest position.
Transfer charger
Transfer elevator
drive shaft