Microplex SOLID F40 - Page 98

98 Operator Maintenance
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
!
4. Place the charger onto a clean and level worktop.
5. Using the blower brush, remove paper dust and other
unwanted particles.
6. Clean the wire using the wire cleaning tool. After having
finished this procedure the wire should be completely smooth.
7. Replace the charger in its original position and fasten
the knob screw to secure the charger.
8. Close the waste toner unit.
Make sure the bar has engaged.
9. Close the printer’s front cover.