MicroRidge MobileCollect Digital - Chapter 3 Gage Cables; Cable Lengths

Gage Cables 4
Copyright © 2011-2017 MicroRidge Systems, Inc.
MobileCollect Selection Tool
3 Gage Cables
A gage cable is required to connect a Mobile Module to a gage. There are 3 different types of
gage cables.
§ Cables for Mini Mobile Modules.
§ Cables for Digital and Command Mobile Modules. These 2 Mobile Modules use the same
gage cables.
§ Cables for RS-232 Mobile Modules.
When you select a gage in the MobileCollect Selection Tool, the Mobile Module required for this
gage will be automatically selected.
3.1 Cable Lengths
The cable lengths displayed in the MobileCollect Selection Tool are the default length used with
each gage model. If you do not specify a cable length at the time of order, the default cable
length will be shipped. The standard cable lengths are as follows:
Length
Typical Usage
3.5"
Standard for calipers
6.5"
Most micrometers & indicators
9"
Available by special request
12"
Available by special request
18"
Available by special request
24"
Available by special request