Microsens MS453514M User Manual (English)

Questions and Answers:

A
Anthony DanielsAug 3, 2025
What to do if Port Status LED is Off in Link/Act/Speed Mode on Microsens MS453514M Switch?
- B
  Brandon DouglasAug 3, 2025
  If the Port Status LED is off in Link/Act/Speed Mode on your Microsens Switch, it means the port isn't connected or the connection isn't working. Here's what you can do: 1. Ensure the cable connector is firmly inserted and locked into the port on both the switch and the connected device. 2. Verify the connected device is running correctly. 3. Try a different cable or port to see if the issue is with the cable or a specific port. 4. Check the WEB user interface to ensure the port is enabled in the configuration settings.
A
austinrichardsonAug 10, 2025
How to troubleshoot SYSTEM LED being Off on Microsens MS453514M?
- B
  Bruce BrownAug 10, 2025
  If the SYSTEM LED is off on your Microsens Switch, the device isn't receiving power. To resolve this: 1. Check that the power cord is correctly connected to both the switch and the AC outlet. 2. Power cycle the switch by unplugging it and plugging it back in. 3. Try plugging the power cord into a different AC outlet to ensure the AC source is working.
T
Todd JacksonAug 18, 2025
What to do if Port Status LED is Off in the PoE Mode on Microsens MS453514M Switch?
- T
  traceywardAug 18, 2025
  If the Port Status LED is off in PoE Mode on your Microsens Switch, it indicates the port isn't supplying power. Try these steps: 1. Make sure the cable connector is firmly inserted and locked into the port on both the switch and the connected device. 2. Ensure you're using the correct Ethernet cables. 3. Try a different cable or port to identify if the issue is with the cable or a specific port. 4. Check the WEB user interface to see if the port is disabled in the configuration settings.

Microsens MS453514M Specifications

General

MAC Address Table Size	8K
VLANs	256
Layer	L2+
Power Supply	100-240V AC, 50/60Hz
Weight	2.5 kg
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Management	Web-based GUI, CLI
Operating Temperature	0°C to 45°C (32°F to 113°F)