Microsoft HoloLens User Manual

Advanced HoloLens Controls in Web Interface
Accessing Web Interface
Connecting to WiFi
In order to access the HoloLens web interface, the user must tether the device to a computer
using a WiFi connection. Ensure that both devices (HoloLens and the computer) are connected
to the same WiFi network and that network credentials are entered if required. For instructions
on connecting the HoloLens device to WiFi, refer to the section Connecting to WiFi.
Locating IP Address
1. From the HoloLens start menu, launch and pin the ‘Settings’ application:
2. Select the ‘Networking & Internet’ button to open the device’s network settings:

Microsoft HoloLens Specifications

General

Product Type	Augmented reality headset
Refresh Rate	60 Hz
Battery Life	2-3 hours of active use
Weight	579 grams
Display Technology	See-through holographic lenses
Resolution	2.3M total light points
Audio	Spatial sound
Connectivity	Wi-Fi 802.11ac, Bluetooth 5.0
Operating System	Windows Holographic
Sensors	Ambient light sensor
Storage	64GB flash storage