Sensitivity knob, adjust and set the sensitivity.
In the plasma mode and the manual mode, press it for one-button location, the torch moves
down, and touches the zero point switch, and then moves up to the location height and stops.
In the flame mode and the manual mode, press it 2s for one-button calibration.
LED screen, display settings and working information
Indicator lights, display working states
2-2 Quick start procedure
plasma mode
Power on it, choose the plasma mode press the sensitivity button for the initial location
(and press the height button to adjust b value) manually cut a line to check the arc voltage
value in LED screen set that arc voltage value for auto height start auto cutting to check
the height (adjust the arc voltage height and sensitivity) finish setting.
To Next Page
Loading...
Need help?
General