DIGITAL PROPORTIONAL R/CSYSTEM
www.microzone.cn
2.4GHz
FHSS
Power on:
Connect the positive and negative terminals in to the power supply to turn it on.
Indicator Description:
Slow blinking: no signal;
Indicator light is always on: signal reception is normal;
Fast blinking: frequency pairing is in progress.
Fail-safe:
When the receiver accidentally loses signal, it will automatically switch to runaway state, when runaway, the
receiver outputs 1500us on channel 1/2/4, 900us on channel 3, and the other channels remain unchanged.
Failsafe switching:
This function is only available for products after 2023, and this operation will change the runaway protection
value of channel 3 to 1500us;
Turn off the receiver, short-circuit channels 5 and 6 with a wire, turn off the wire after the How to Operate:
receiver is powered on for three seconds, and restart the receiver.
Frequency pairing:
After the remote control is turned off and the receiver is powered on, press the frequency control button on
the receiver, and the indicator light will flash quickly, the receiver will enter the frequency control mode, as
shown in the following figure, then, turn on the remote control, and the receiver indicator light will turn on,
the receiver will receive the signal normally.
PARTICULAR
FM button
To Next Page
Loading...
