EasyManua.ls Logo

Middleby Marshall Oven - User Manual

Middleby Marshall Oven
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
2-1
SECTION 2
INSTALLATION
WARNING
Do not obstruct the flow of combustion
and ventilation air to and from your
oven. There must be no obstructions
around or underneath the oven.
I. UNLOADING/UNPACKING
Your Middleby Marshall Ovens are shipped partially assembled.
Each oven section will arrive in its own crate of the following
size and weight:
PS360U/PS360L PS360WB-U/PS360WB-L
Length: 72 (183cm) 66 (167cm)
Width: 48 (122cm) 57 (144cm)
Height: 60 (152cm) 50 (127cm)
Weight: 1675 lbs. (760kg) 1750 lbs. (780kg)
If you ordered stands for your ovens, they are shipped in
separate crates.
When your common carrier or truck line notifies you of delivery,
you must have a forklift at the facility to unload the crate(s).
If you have a door that is wider than the ovens, simply move the
ovens into your facility and set up an appointment with your
Middleby Marshall Authorized Installer.
NOTE: The width of each oven can be reduced by about 1"
(25mm) by removing the window from the oven. Window
disassembly instructions are in the Cleaning section of this
Owners Manual.
If the ovens are wider than your door opening, the oven will
have to be dismantled according to the directions in the Pre-
Installation Procedures Manual.
SECTION 2
INSTALLATION
NOTE
There must be adequate clearance
between the oven and combustible con-
struction. Clearance must also be pro-
vided for servicing and for
operation.
WARNING
This oven must be installed in accordance
with the rules in force. Use only in a
well ventilated area. Read the
instructions before use.
Question and Answer IconNeed help?

Do you have a question about the Middleby Marshall Oven and is the answer not in the manual?

Summary

I. UNLOADING;UNPACKING

II. INSTALLATION, PREPARATION, AND SUPPLY

III. VENTILATION SYSTEM

IV. THERMOCOUPLE INSTALLATION

V. ASSEMBLY

JOINING THE OVEN BODIES

Instructions for connecting multiple oven units together for installation.

INSTALLING THE CONVEYOR FRAME AND BELT

GAS OVEN ROUGH-IN

VI. ELECTRICAL CONNECTION

VII. GAS SUPPLY FOR GAS HEATED OVENS

VIII. PREPARATION FOR VARIOUS GASES

IX. CHANGING ORIFICES

TO CHANGE MAIN ORIFICE

Steps to replace the primary gas orifice for specific gas types.

TO CHANGE BYPASS (LOW FLAME) ORIFICE

Steps to replace the low flame gas orifice for specific gas types.

X. VOLUMETRIC METHOD

XI. VARIATIONS OF RATED SUPPLY PRESSURES

TO CHECK GAS SUPPLY PRESSURE

Procedure for measuring and verifying the incoming gas supply pressure.

ORIFICE (MANIFOLD) PRESSURE METHOD

Method for adjusting and verifying the manifold pressure using an orifice.

SPECIAL NOTICES

Middleby Marshall Oven Specifications

General IconGeneral
BrandMiddleby Marshall
ModelOven
CategoryOven
LanguageEnglish

Related product manuals