13 14
Function of Buttons
OPERATION INSTRUCTIONS
Power switch
(under the cover)
Start/Pause
ON / OFF
ON: Open the cover and slide power switch to “I” position to turn on the robot.
OFF: Slide power switch to “O” position to turn o the robot.
Start / Pause
Start: Short press button or use App or remote controller to start cleaning.
Pause: Short press to pause the cleaning. To resume cleaning, briefly press again.
Networking
Press and hold the network pairing button for network configuration. Robot is in pairing
status if the light is flashing.
Remote Controller
Remote controller will work when within 16 feet of the robot.
NOTE
Direction
Manually control the direction of the robot (forward, left, and right). Note that the robot does not
vacuum when in manual mode.
Edge cleaning
The robot will clean edges of the room and furniture.
Zig-zag cleaning
The robot will clean in a zig-zag route.
Suction increase
Increase the suction power.
Suction decrease
Decrease the suction power.
Spot cleaning
The robot will clean a special area in a spiral pattern.
Start/Pause
Start or pause cleaning. The robot will automatically begin Smart Path cleaning.
Recharging
The robot will return to the charging base for charging.
Direction
Edge cleaning
Zig-zag cleaning
Suction increase
Suction decrease
Spot cleaning
Start/Pause
Recharging
1.
2.
Before using the remote control, insert the 2 included AAA batteries. Remove back battery cover
and insert in correct orientation.
To prevent the robot from accidentally falling down, the backwards direction button doesn’t work.
NOTE
To Next Page
Loading...
Need help?
General
