ITEM PICTURE HOW TO DISASSEMBLE
Unscrew the screws on the Top cover
normally 2 sides 2 back. It varies
according to different designs
）
Take down the top cover, and put it
in the right place ( avoid to scratch the
top cover)
Remove the PCB
Unscrew the controller board
screws, pull out the controller
plug wire and connect wires,
you must insert terminals to
the roots for not easily pulling.)
Take down the controller board
and the front control panel
• Unplug power cord for the work such as disassembling
which is not unnecessary to power on . Do not hold the plug
by a wet hand.
Failing to unplug may cause an electric shock.
WARNING
12
To Next Page
Loading...
