Midea MB-FZ3015 - Clock Adjustment and Power Failure Handling

Usage Instructions
Warm Tips:
No time setting under the condition of power failure.
Clock display not accurate will affect the preset time, please calibrate display time.
If enter the clock adjustment state without adjustment, the figure of the display screen
will be flicker for about 12 seconds then stop and automatic confirm.
Clock Adjustment
If finding the inaccuracy of the clock on the product, please make
adjustment according to the following steps:
Only for the product with this function
Battery and Power Failure
Memory function
Warm Tips:
1. A new battery has a service life of 5 years;
2. If the battery is about to be used up, battery replacement
shall be carried out in an authorized service agency;
3. Never place the battery into fire or water.
4. Never heat, decompose or recharge the battery.
Power failure in heating: after power resumes, the app
-liance will be in standby if the time of power failure
exceeds 2h, and will continue heating until the end
if the time is within 2h.
In case of power failure, the built-in battery provides
power supply to the clock display.
In case of power failure
After power failure, the LCD shows nothing, without the
power failure memory function. After power resumes, the
LCD shows C0. Press “Keep Warm/Off” to return to standby,
LCD shows 12:00 and then cooking operation is allowed.
Only for the product with this function
Power-off while appointment: if power again before the
work, but the preset finish time may be bias; if after the preset complete
standby state
preset complete time, continue to
time, then enter
Power failure in warm-keeping: timing continues, and
will be in standby if the time of power failure exceeds 2h, and will continue
if the time is within 2h.
after power resumes, the appliance
warm-keeping
保 温
关
KEEP WARM
OFF
关
OFF
6 seconds after completion of clock adjustment,
confirms automatically or is confirmed
“Start” key.
Connect power supply to
enter
standby.
Press ”Hour””Min” button
for
three seconds then
display.
enter clock
time the “MIN” key is pressed and quick accumulation
Adjust time with the “Hour” or “Minute” key.1h increases
each time the “HRS” key is
pressed and quick accumulation
achieved if the key is kept pressed. 1min increases each
if the key is kept pressed.achieved
the clock
by pressing the
时
HRS
分
MIN
11