1. Touch the ON/OFF control. After power on,
the buzzer beeps once, heating zone
selection controls show “ - ” , indicating that
the induction hob has entered the state of
standby mode.mode.
2. Place a suitable pan on the cooking zone that
you wish to use.
• Make sure the bottom of the pan and the
surface of the cooking zone are clean and
dry.
How to Use
1. Start Cooking
17
Pan Dimension
• Make sure that the base of your pan is smooth, sits flat against the glass, and is the same size as the
cooking zone. Use pans whose diameter is as large as the graphic of the zone selected. Using a pot a
slightly wider energy will be used at its maximum eciency. If you use smaller pot eciency could be
less than expected. Pot less than 140 mm could be undetected by the hob. Always centre your pan on
the cooking zone.
The cooking zones are, up to a limit, automatically adapted to the diameter of the pan. However the
bottom of this pan must have a minimum of diameter according to the corresponding cooking zone. To
obtain the best eciency of your hob, please place the pan in the center of the cooking zone.
• Always lift pans o the Induction hob – do not slide, or they may scratch the glass.
Cooking zone
The base diameter of induction cookware
Minimum (mm) Maximum (mm)
1,2,3,4 100 220
flex induction
210
220x380
To Next Page
Loading...
