H/h will show which cooking zone is hot to
touch. It will disappear when the surface has
cooled down to a safe temperature. It can
also be used as an energy saving function if
you want to heat further pans, use the
hotplate that is still hot.
• If you don’t choose a heat setting within 20
seconds, the Induction hob will automatically
switch o. You will need to start again at
step 1.
• You can modify the heat setting at any time
during cooking.
2. Finish Cooking
1. Touch the slider of the corresponding
burner to the far left, make sure the display
shows “0”, after 3s the cooking area is
turned o, and the display shows “-”.
4. Adjust heat setting by touching the slider
control.
3. Each hob has its own independent slider,
boost, timing operation button, which can
independently operate the power
level/timing function.
2. Turn the whole cooktop o by touching the
ON/OFF control.
3. Beware of hot surfaces
18
OR
Power up
Power down
Power down
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you’re using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn o after 1 minute if no suitable pan is placed on it.
If the display flashes alternately with the heat setting
To Next Page
Loading...
