Note
• The function can work in all cooking zones
• The cooking zone returns to its original setting after 10 minutes.
• The flex cooking zone returns to its original setting after 5 minutes.
• As the boost function of 1st cooking zone is activated, start 2nd cooking area, and the 1st cooking
area will automatically change to level 9. Vice versa.
• If the original heat setting equals 0, it will return to 9 when boost ends.
3. Using the Boost Function
4. Flexible Area
Activate the boost function
1. Touch the ON/OFF control. After power on,
the buzzer beeps once, heating zone
selection controls show “ - ” , indicating that
the induction hob has entered the state of
standby mode.
2. Touching the boost control “B” , the zone
indicator show “Marquee” and the power reach
Max.
19
Cancel the Boost function
1. In boost mode, the operation slider will exit
the boost mode, and the gear will be
displayed in the display area.
2. After the boost operation time reaches, it will
automatically exit the boost mode and return
to the level before entering the boost mode . If
the level before entering the boost mode is 0,
it will become level 9 for operation.
• This area can be used as a single zone or as two dierent zones, accordingly to the cooking needs
anytime.
• Flexible area is made of two independent inductors that can be controlled separately. When working
as a single zone, the part that is not covered by cookware is automatically switched o after 8
seconds.
• To grant a correct pan detection and a even heat distribution, the cookware should be correctly
placed:
- In the front or rear side of the flexible zone when the cookware is smaller than 21 cm.
- Anywhere with bigger cookware.
To Next Page
Loading...
