Error code of engineer mode
Indoor unit EEPROM parameter error
Indoor / outdoor unit communication error
Communication error between indoor unit and indoor external fan module
Parameters error of indoor external fan
Phase failure of indoor external fan
Indoor external fan current sampling bias fault
Indoor external fan zero speed failure
Indoor external fan stall failure
Out of step failure of indoor external fan
Low voltage protection of indoor external fan DC bus
Indoor external fan DC bus voltage is too high fault
Indoor external fan overcurrent fault
Indoor external fan module protection/hardware Current overload protection
The indoor fan speed is operating outside of the normal range
Outdoor unit EEPROM parameter error
Condenser coil temperature sensor T3 is in open circuit or has short circuited
Outdoor room temperature sensor T4 is in open circuit or has short circuited
Compressor discharge temperature sensor TP is in open circuit or has short circuited
IGBT temperature sensor TH is in open circuit or has short circuited
Indoor room temperature sensor T1 is in open circuit or has short circuited
Evaporator coil temperature sensor T2 is in open circuit or has short circuited
Outdoor external fan overcurrent fault
Outdoor external fan module protection/hardware Current overload protection
Outdoor external fan phase failure
Outdoor external fan current sampling bias fault
Zero speed failure of outdoor unit DC fan
The outdoor fan speed is operating outside of the normal range(
Refrigerant leak detected
Water-level alarm malfunction
IPM malfunction or IGBT over-strong current protection
Over low voltage protection
Top temperature protection of compressor or High temperature protection of IPM module
Communication error between outdoor main chip and compressor driven chip
Current Input detection protection
Lack of phase (3 phase) protection