Midea MD100A70 - Trouble Shooting

18
Trouble Shooting
Problem Cause Solution
Dryer does
not start
The appliance
gets hot or
burnt smell
Clothes are
too dry
Clothes shrink
Pilling on
clothes
• Power cut off.
• The power plug is not
plugged tight.
• The dryer is overloaded.
• The temperature fuse is cut.
• The lint filter is clogged.
• The uptake or exhaust duct is
clogged.
• The machine is overloaded.
• Clothes are not taken out in
time after finish.
• Clothes are not sorted
properly.
• The selected temperature is
too high.
• Laundry is over-dried.
• Laundry is sensitive for
rubbing.
MAINTENANCE
• Wait for restore of electricity.
• Check the power socket,make sure the plug
is inserted tightly.
• The clothes must be spun and drying load can
not exceed the rated capacity.
• Restore the temperature fuse.
• Observe the care label on clothes.
• If items are sensitive to shrink, examine the
clothes when dry. Take out the clothes when
damp.Then hang the clothes until fully dry.
• Use fabric softener to lubricate fibres,
please spray laundry starch on cuff and
neckline when ironing clothes. Turn the
laundry inside out to avoid pilling
• Make sure to clean the lint filter after
each cycle.
• Clean the exhaust duct.
• Do not exceed the rated capacity.
• Take out the clothes immediately after
programme end.
• Observe the care label on clothes.
Heavy wet clothes turning and bumping will cause noise accordingly while to dryer runs.
During the drying cycle, the machine will create airflow, which will cause noise when hitting
the drum.