5
SAFETY INSTRUCTIONS
Power supply and grounding
•
• The dryer employs alternating current with the rated voltage and frequency.
When the voltage fluctuates between 6% of rated voltage, the dryer can work normally.
• A special power socket with a capacity 10A for the dryer had better be set beside the
dryer for convenience and safety. The method of connection of the socket is as the
figure below.
• To be safe, please make improvements as soon as
possible according to the rules and
suggestions mentioned above.
• The appliance corresponds to protection class I and may only be connected to a plug
with a protective conductor that has been installed properly. When connecting the
appliance to the mains, make sure that the mains voltage is correct. You can find more
information about this on the rating plate.
• The electrical safety of this tumble dryer can only be guaranteed when correctly
earthed. It is essential that this standard safety requirement is met. If in any doubt,
please have the household wiring system tested by a qualified electrician.
The manufacturer cannot be held liable for the consequences of an inadequate
earthing system (e.g. electric shock).
The socket and the grounding wire must be installed by an electrician to prevent
incorrect installation or use of the socket and to guarantee the safe use of
electricity. No connection of the grounding wire and the neutral wire, otherwise the
cabinet will be charged, which is likely to cause the danger of electric shock.
≥
Warning!
！
Grounding
To Next Page
Loading...
