4.6 Switch on the power source, press the “start/pause” button,
This might caused by the fault of door lock, make the PCB board detected that the door is open
4.7 The dryer is running, open the door but the dryer still running.
4.8 When the dryer is running, the air volume of outlet was little.
1.Check whether the inlet was obstructed; keep the freely flowing of air inlet;
2.Check whether the filter was obstructed, get it out and cleaned.
4.9 The dryer keep running a long time while drying fewer clothes.
It is suggest to you take the 1 hour program. If it still cannot solve the problem, please check
4.10 The drum of the dryer cannot rotate efficiently.
The dryer cannot work efficiently when you put the clothes of rated capacity. It may be caused by the questions:
；And then the weak belt make the drum of the dryer cannot rotate efficiently. In this case, please replace the belt
2.The extenuation of the spring of the pulley spring leads to the weak force of pulley .This can also
3.Because of the faulty connection of the capacitor, the motor cannot work normally;
4.11 When you find the cabinet have current in the using process.
You should check it drain current or faradic current. It is very dangerous if it caused by drain current. It is usually
caused by some electrical parts are short-circuited or damaged by moisture or the wire's insulative parts touch
the metal parts under the fracture, etc. It is the faradic current if you find the electroprobe light when you put it on the
dryer's cabinet. In this case, please check the dryer grounded. or not. You should check it and exclude it
4.12 The key doesn't work under the normal condition.
The dryer's key doesn't work under the normal condition, it may be caused by the questions:
1.The button is droped or dislocated;
2.The key of the control panel is partly damaged;
3.The key of the PCB board is broken.
This might caused by the fault of door lock, make the PCB board detected that the door
1.Due to the belt had been fretted away flabbily and the wedge type is damaged,.the belt works skidded .
4.Maybe the capacitor is aged. In this case, please replace the capacitor.
4.PHENOMENON OF THE FAULT
the dryer doesn't work but alarm.
Analysis and maintenance:
Analysis and maintenance:
and alarmed, replace the door switch.
Analysis and maintenance:
Analysis and maintenance:
Analysis and maintenance:
Analysis and maintenance:
Analysis and maintenance:
is closed, replace the door switch.
the thermostat and replace it after you are sure the thermostat is error.
make the belt skidding and the drum of the dryer cannot rotate efficiently.
In this case, please replace the pulley spring；
- 11 -
To Next Page
Loading...
