Midea MDC17P0ABB - Troubleshooting Tips; Before Calling for Service

Before calling for service
Reviewing the charts on the following pages may save you from calling for service.
Problem Possible Causes What To Do
Dishwasher doesn't
start
Fuse blown, or the
circuit break tripped.
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Power supply is not
turned on.
Make sure the dishwasher is turned
on and the door is closed securely.
Make sure the power cord is
properly plugged into the wall socket.
Check that the water supply is
connected properly and the water
is turned on.
Door of dishwasher
not properly closed.
Make sure to close the door
properly and latch it.
Water not pumped
from the dishwasher
Kinked or crushed
drain hose.
Filter clogged.
Check the drain hose.
Check coarse the filter.
Check the kitchen sink to make sure
it is draining well. If the problem is
the kitchen sink that is not draining ,
you may need a plumber rather than
a serviceman for dishwashers.
TROUBLESHOOTING TIPS
is too high
Error code: E1;
Water pressure is low
Raise the dishwasher so reduce the
height the dishwasher must lift the
water (39-1/4" max) or try draining
into a bucket.
-26
-
Kitchen sink clogged.
Drain hose routing