Midea MDV-D22Q1/N1-D

3.9. FE Troubleshooting
3.9.1. Display output
or
OPERATION and
TIMER LEDs flash
3.9.2. Description
▪ Indoor unit has not been assigned an address.
3.9.3. Impact on other units
▪ Refer to 4.2 “Impact on Other Units”.
3.9.4. Possible causes
▪ Indoor unit has not been assigned an address.
3.9.5. Procedure
FE
Indoor unit has not been assigned an
address
Yes
Assign an address to the unit
1
Notes:
1. Indoor unit addresses can be manually assigned using indoor unit remote/wired controllers. Alternatively, indoor unit addresses can be automatically
assigned by the master outdoor unit. Refer to the outdoor unit technical documentation. Note: Each unit in a system should be assigned a unique
address - unit addresses should not be repeated within one system.