Midea MFW-801S - Full Automatic Wash Program Details; Program Cycle Times; Laundry Capacity and Water Level; Cleaning and Maintenance

Note: The time required will also vary with water pressures of intake pipe, different clothes
textures and different water drain conditions.
16
About the procedure of full automatic wash program
Contents
Program
Wash
Time
(minutes)
Rinsing
Times
Spin
Time
(minutes)
Complete
Time
(minutes)
Normal
Jeans
Delicate
Bulky
Quick
Mini wash
Air dry
12
5
43
2
12
3
12
Tub clean
5
2
2
5
2
63
35
39
13
43
5
4
2
2
2
2
Laundry capacity and water level setting
Only drain
Spray rinse
1 minute
Soak 20 minutes
+
wash12 minutes
Soak10 minutes
+
wash 6 minutes
Level(L)
Weight of
laundry(kg)
20
<0.8
26 31 37 42 47 52 58
<1.6 <2.4 <3.2 <4.0 <4.8 <5.8 <8.0
Cleaning and Maintenance of the washing machine
End of program
The washing machine will send off the sound
of dou-dou at the end of any program operation
to remind you to take out the laundry or operate
it again.
After the sound ,the washing machine returns
to its power-off state with no display and all lights off.
Please shut off the tap, pull out the plug when not
in use to avoid water leakage or the fire accidents.
" "
Maintenance
Use gentle clothing to wipe off the water and dirt on
the surface each time after using the washing machine.
Detergent , propellant and
other chemicals are not
allowed to use so as to avoid
any damage to the plastic
accessories.
Clean the water inlet
Clean the lint filter in the drain pump (only for having drain filter)
2. Loosen the pump cover
anticlockwise.
3. Take out the lint filter.
4. Clean the filter.
5. Restore it and adjust the
convex place to align at
the pump hole.
6. Tighten the pump cover
clockwise.
If the drain filter is not cleaned at proper time (every 10 times of use),Drain problem could be caused.
Notes:
Clean Of the filter
After long time use, the water inlet mesh
bag may be blocked with smudginess, and
should be cleaned according to the following
steps:
1. Switch on the power, followed by shutting off
the tap .
2. Let the washer works for 5 seconds so that
water flows into the tub through the water inlet
hose. then turn off the power.
After using the washing machine for a period,
please clean it according to the following
steps:
1. Take out the lint filter.
2. Turn the mesh bag outside and wash it
clean in the water.
3. Restore it and refix it.
1 .Drain the water from the
pump,and collect it with a
container.
1
15