Midea MSXE-10CRDN8 - Page 49

47
40
ECO/GEAR function


following:
ECO GEAR(75%) GEAR(50%) Previous setting mode ECO......
Note:This function is only available under COOL mode.
Under cooling mode, press this button, the remote
controller will adjust the temperature automatically
to 24 C/75 F, fan speed of Auto to save energy
(only when the set temperature is less than
24 C/75 F). If the set temperature is above
24 C/75 F, press the ECO button, the fan speed
will change to Auto, the set temperature will
remain unchanged.
O
O
O
O
O
O
ECO operation:
GEAR operation:
Press the ECO/GEAR button to enter the GEAR operation as following:
75%(up to 75% electrial energy consumption) 50%(up to 50% electrial energy consumption)
Previous setting mode.
Under GEAR operation, the display on the remote controller will alternate between electical energy
consumption and set temperature.
O
O
O
O
NOTE: Pressing the ECO button, or modifying
the mode or adjusting the set temperature to
less than 24 C/75 F will stop ECO operation.
Under ECO operation, the set tmeperature
should be 24 C/75 F or above, it may result in
just press the ECO button again to stop it.
FP function
O
O
O
O
Keep pressing Fan button for more than 2 seconds to activate/disable Silence function.
heating capacity. Press ON/OFF, Mode, Sleep, Boost or Clean button while operating will
cancel silence function.
Silence function
Press this button 2 times during one second under HEAT Mode and setting temperature of 16 C/60 F
to activate the FP function.
The unit will operate at high fan speed (while compressor on) with temperature
automatically set to 8 C/46 F.
2
2s