48
Sleep function
AP function(some units) :
Follow me function
SET function
or
SET
SET
OK
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
The FOLLOW ME function enables the remote
control to measure the temperature at its
current location and send this signal to the
air conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the
remote control(instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
The SLEEP function is used to decrease
energy use while you sleep(and don’t
need the same temperature settings to
stay comfortable).
,
,
,
,
,
,
,
,
If the memory feature is stopped, OF
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
NOTE: Press and hold Boost button for
seven seconds to start/stop memory
feature of Follow Me function.
If the memory feature is activated,
On
displays for 3 seconds on the screen.
Choose AP mode to do wireless network
configuration. For some units, it doesn’t
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
NOTE: The SLEEP function is not available
in FAN and DRY mode.
Breeze Away ( ) Air magic/UV lamp ( ) Sleep( ) Follow Me( ) AP mode ( )
[ ]: If your remote controller has Breeze Away button or Air magic button, you can not use the SET
button to select the Breeze Away or Air magic/UV lamp feature.
*
*
*
*
This feature avoids direct air flow blowing
on the body and makes you feel indulging
in silky coolness.
NOTE: This feature is available under cool,
Fan and Dry mode only.
Breeze Away function (some units) :
Air magic/UV-C function(some units)
When the Air magic function is initiated, the
ion generator is energized and will help to
purify the air inside. When the UV function
is initiated, the UV lamp emit UV-C radiation
to help to purify the air inside.
To Next Page
Loading...
