3. WATER HEATER INSTALLATION
a. Determine installation position of the unit according to length of power cord /
position of air switch (Distance between bottom and
should be ≥1.6m).
b. Make sure the distance between the unit and surrounding wall is not less than
300mm, so that to have enough space for maintenance purpose.
c. Determine the position of four
screws (attached with the unit), make four holes with
corresponding depth in the wall by means of a drill and drive a wall plug into the hole.
d. Drive in the screws on the top and ensure certain distance between screw head and
wall (See Fig. 3).
e. Mount the unit on the wall and tighten with two screws at bottom, connect the wires
and install top cover with the screws.
4. PLUMBING CONNECTION
a. Water valve with should be installed at water inlet of the unit, sealing ring with
should be used at end face. (See Fig. 4).
b. Shower
tube should be connected with water outlets and shower head
separately, attached sealing ring should be used at end face.
WARNING: Metallic / chromed hose and conductive control valve shall not be used.
Fig.3
To Next Page
Loading...
