13
Air Conditioner Features
Electronic Control Operating Instructions
Before you begin, thoroughly familiarize yourself with the control panel as shown below
and all its functions, then follow the symbol for the functions you desire. The unit can be
controlled by the unit control alone or with the remote controller.
TO CHANGE TEMPERATURE SETTING:
Press UP/DOWN button to change
temperature setting.
TO TURN UNIT ON OR OFF:
TO ADJUST FAN SPEEDS:
Press the Fan button to select the Fan
Speed in four steps-Auto, Low, Med or
High.
Each time the button is pressed, the fan
speed mode is changed. On Dry mode,
the fan operates on Low speed
automatically.
NOTICE
The unit will automatically initiate the
Energy Saver function under Cool, Dry,
Auto (only Auto-Cooling and Auto-Fan)
modes.
NOTICE
Press or hold either UP ( ) or DOWN ( )
button until the desired temperature is
seen on the display.
This temperature will be automatically
maintained anywhere between 62°F
(17°C) and 86°F (30°C). If you want to
display the actual room temperature,
see To Operate on Fan Only section.
SLEEP FEATURE:
Press the Sleep button to initiate the sleep
mode. In this mode the selected temperature
will increase by 2°F (1°C) 30 minutes after
the mode is selected. The temperature will
then increase by another 2°F (1°C) after an
additional 30 minutes.
This new temperature will be maintained
for 7 hours before it returns to the originally
selected temperature. The Sleep mode
program can be canceled at any time during
operation by pressing the Sleep button again.
CHECK FILTER FEATURE:
The Check Filter feature is a reminder
operation. The light will illuminate after 250
hours of operation. After cleaning the filter,
press the Filter button to reset the Check
ECO (ENERGY SAVER) FEATURE:
Press the ECO button to initiate this
function. This function is available on COOL,
DRY, AUTO (only AUTO-COOLING and
AUTOFAN) modes. The fan will continue to
run for 3 minutes after the compressor
The fan then cycles on for 2 minutes at 10
minute intervals until the room temperature
is above the set temperature, at which time
the compressor turns back on and Cooling
resumes.
Operating
Instructions
Timer
Button
ECO
Button
Mode
Button
Power
Button
Fan
Button
Sleep
Button
Connect
Button
LED
Display
Remote Signal
Receptor
Filter
Button
Up ( ) and Down ( ) Buttons
To Next Page
Loading...
