Cooking Preparation
Safe Lid Opening
1. Make sure the pressure cooking program has completed or press “Cancel” key to
terminate the program.
2. Releasing pressure in one of the following approaches.
Quick Release:
● Press the “Steam Release ” key on the lid handle to let out steam until the float valve
drops down.
Caution:
● Please keep hands and face away from the hole on the top of the exhaust valve when
using Quick Release. The escaping steam is very hot and can cause scalding.
● Never pull out the exhaust valve when it is letting out steam.
● Please be aware that Quick Release is not suitable for food in large liquid volume or
with high starch content (e.g. porridge, congee, sticky liquids, soup, etc.). Food content
may splatter out with steam. Use Nature Release instead.
Nature Release:
● Allow the cooker to cool down naturally until the float valve drops down. This may take
10 to 15 minutes after cooking is finished and the cooker is in Keep-Warm mode.
● Putting a wet towel on the lid can speed up cooling.
3. Open the lid: Hold the lid handle, turn the lid counterclockwise to the open position, and
lift the lid up to open.
● Caution: Do not open the lid until pressure inside the pot is completely released. As a
safety feature, until the float valve drops down, the lid is locked and cannot be opened.
● If the float valve is stuck due to food debris or stickiness, you can push it down with a
pen or chopsticks when you are certain the pressure has been released by pressing
the “Steam Release ” key on the lid handle.
1. Open the lid
Holding the lid handle with your hand, rotate counter- clockwise
approximately 30 degrees until the end.
2. Check whether all parts on the lid are assembled properly
Check the float valve and exhaust valve for obstructions. Make
sure that the sealing ring is well seated inside its holding rack,
the anti-block shield is installed properly and the float valve can
move up and down easily.
7
To Next Page
Loading...
Need help?
General
