2）控制板插好线束后安装到顶壳上，然后扣
上顶盖。
2) Insert the wires into the control board, and
install the control board on the top cover.
3) 将顶盖与顶壳扣在一起。
3) Install the top cap and the top cover
together.
4)将遥控接收板安装到前壳上，将顶壳组件
顺着前壳的滑槽装入前壳，确保顶壳的两个
扣位扣住前壳的筋位。
4) Install the remote control receiving board on
the front cover. Install the top cover
assembly into the front cover along the
sliding groove of it, ensure that the two buckles
of the top cover engage the ribs of the front
cover.
1) 将电源板及电容安装在 PCB 盒内。
1) Install the power PCB and capacitors on the
PCB box.
2)按照布线指引接好线束。
2) Connect the wires according to the wiring
guidelines.
3) 将 PCB 盒安装在前壳上，布好线束。
3) Install the PCB box on the front cover, lay
out the wires.
To Next Page
Loading...
Need help?
General
