MCAC-RTSM-2013-12 Midea High-temperature Direct-heating Heat Pump Water Heater Technical Manual
42
3) Water pump (reserved for future use.)
This function is used to run the main water pump in the device installing and debugging.
Operation method: when the wire controller is set to be 1, press “AUXILIARY” key 3 times to enter
this function. “ ” icon will flash and then press “OK” key to confirm.
4) Cancel auxiliary: To stop the auxiliary function, press the “AUXILIARY” key again, and then press
“CANCEL” key when the corresponding icon is flashing. Then the auxiliary function will be
cancelled.
To Next Page
Loading...
Need help?
General
