Midea R410A Direct Heating Commercial Heat Pump 50Hz Technical Manual MCAC-HTSM-201506
69
Check timing information: to check the timing which has been set, press or
key under main page, the on and off time of Timer 1, Timer 2 and Timer 3 will be
displayed in turns.
Cancel timing: press and hold CANCEL key for 3 seconds, then all the effective
timing periods will be cancelled.
To avoid timing error, each period of timing should not be crossed, e.g.:
Set the cycle heating water temperature (Reserved)
Continuous press SET key 3 times to enter cycle heating water temperature
setting. The LCD will display ‘SET CYCLE WATER TEMP.’ and temperature value
will flash.
Press the ▲ or ▼ key to adjust the temperature value, press OK key or wait for 7
seconds to confirm. During setting process pressing CANCEL key to exit without
saving.
Check cycle water temperature value setting: press or key under main
page to check the value.
Set clock
Press the SET key 4 times to enter clock setting. The hour of the clock will flash, which
means the current setting is the hour of the clock, press the ▲ or ▼ key to adjust, press
To Next Page
Loading...
