Side view of fan assembly
installation state
Front view of fan assembly installation state
Fan assembly should
push horizontally to the
end (about 18mm), and
then take o f f it.
The state after fan assembly is taken off
12-Screw
For fixing the satety drain tray
4 Bolts
For fixing the fan assembly
Fig.4-18
Fig.4-17
maintenance of motor：
Inside of structure
Safety Drain Tray
Motor Assembly
Filter
Move 18mm
Move
Scroll
Pothook
CAUTION
1. Refer to Fig.4-17, remove all 1 1
screw
from safety drain tra y , and take o f f the safety drain tra y .
3. Refer to Fig.4-17, remove all 4 bolts from fan assembly, see Fig.4-18, accor ding to which orders to take off the fan assembly.
3. Refer to Fig.4-18, horizontal pushing the fan assembl y , until it cannot not move any furthe r , and then lift up slightly and take down to remove it.
4. After motor maintenance, reinstall the fan assemblies as per the reverse a bove orders. And connect the motor with electric control box, a s
well as motor with power cable of capacity.
1. Please shut down the unit and cut o f f power cable before maintain the moto r .
2. Before dismount the fan assembl y , you must remove the motor and electric control box, as well as connective wires between motor and
capacity assembl y .
3. Fan subassembly is very heav y , please be careful during maintaining, otherwise physical injury would be caused.
8
installation manual
To Next Page
Loading...
