Midea SV 8.45 wi

36


A

B

Step4:Installationstepsforthedishwasher

Pleasefollowtheinstallationstepsspecifiedintheinstallationdrawings.

1.  Applythecondensationstripundertheworktopofthecabinet.
Ensurethatthecondensationstripisflushwiththeedgeofthe
worktop.(Step2)
2.  Connecttheinlethosetothecold-watersupply.
3.  Connectthedrainhose.
4.  Bringthedishwasherintoposition.(Step4)
5.  Thedishwashermustbesecuredinplace.Therearetwowaystodothis:
a)
Normalworktop:Inserttheinstallationhookintotheslotonthe
sideandfastenittotheworktopwiththewoodscrews.
b)
Marbleorgraniteworktop:Securethesidewiththescrew.
6.  Connectthepowercord.
7.  Alignthedishwasher.Therearfootcanbeadjustedfromthefrontof
thedishwasherbyturningthePhillipsscrewinthemiddleofthe
dishwasherbaseusingaPhillipsscrewdriver.Toadjustthefrontfeet,
useaslottedscrewdriverandturnthefrontfeetuntilthedishwasheris
level.(Step5toStep6)
8.  Installthecabinetdoorontheouterdoorofthedishwasher.(Step7to
Step10)
9.  AdjustthedoorspringtensionbyturninganAllenkeyclockwiseto
tensiontheleftandrightdoorspring.Failuretodosocoulddamage
yourdishwasher.(Step11)

