R410A 380~415V 3Ph 50Hz TempMaker Series Split AC MCAC-UTSM-2014-03
119
※ Push the TIMER button and the remote controller will show the last set time for the START
operation and the signal "h" will be shown on the display panel. You are now ready to
readjust the TIMER OFF to stop the operation.
※ Push the TEMP button to cancel the TIMER ON setting. The digital area will show "00".
※ Push the TIMER button and the remote controller will show the last set time for the STOP
operation and the signal "h" will be shown on the display panel. You are now ready to reset
the time of the STOP operation.
※ Push the TEMP button (▲ or ▼) to set the time you want to stop the operation.
※ After setting the TIMER there will be a one-half second delay before the remote controller
transmits the signals to the Air Conditioner. Then after approximately another 2 seconds,
the set temperature will re-appear on the digital display.
c. Set the STARTING & STOPPING time
※ Press the CANCEL button to cancel any former settings.
※ Push the TIMER button and the remote controller will show the last set time for START
operation and the signal "h" will be shown on the display panel. You are now ready to
readjust the TIMER ON to start the operation.
※ Push the TEMP button (▲ or ▼) to set the time you want to start the operation.
※ Push the TIMER button and the remote controller will show the last set time for STOP
operation and the signal "h" will be shown on the display panel. You are now ready to reset
the time of the STOP operation.
※ Push the TEMP button (▲ or ▼) to set the time you want to stop the operation.
※ After setting the TIMER there will be a one-half second delay before the remote controller
transmits the signal to the Air Conditioner. Then, after approximately another 2 seconds, the
set temperature will re-appear on the digital display.
Notes:
1. Please reset the TIMER after cancelling the former time settings.
2. The setting time is relative time. That is the time set is based on the delay of the current time.
Warning
1. Be sure there are no barriers between the remote controller and the receiver of indoor unit
otherwise the air conditioner will not work.
To Next Page
Loading...
Need help?
General
