18
Description
No.1
No.3
No.4
No.2
Power
Press the power button and the gas water heater will stand by,it will work when the
water is turned on.Press the button again ,turn o the power when you don’t need
hot water,then machine will not work(no flame) when you open the hot water faucet.
Ignition
The heat will be lit automatically in stand by condition as you turn on the water
faucet. If no flame is generated after ignition, the screen will report error code. Keep
eyes away from the flame indicator window at a minimum safety distance of
300mm during ignition，the fire signal will also show on the screen. Note : If the
heater is not in operation for a long period, air may enter the gas system. In such
case, please repeat the ignition procedures above for several times.
Temperature screen
The screen will show the temperature you set,the temperature of hot water will
change to the temperature you ordered.(Default temperature is 42°C)
Temperature setting button
Press the ∧/∨ key to set the hot water outlet temperature which is shown on the
screen. The preset range of the water outlet temperature is 35°C~65°C
No.5 Kitchen water mode
Preset mode,the outlet hot water will change into 38°C in this mode. Press the
button again or change setting button to exit mode
Cautions for anti-frozen of the unit
●
●
Neither the electric heating antifreeze method nor the antifreeze drainage method can
prevent freezing of the pipes and valves. All pipelines and valves from the cold water
inlet to the hot water outlet shall be wrapped with heat insulation materials to prevent
freezing.
When freezing has occurred,be sure to thaw it. Make sure there is no water leakage
and the unit is running properly before use.
No.6
No.7
No.8
WIFI CONNECTING
Press the wifi button on the screen for 3seconds and the gas water heater will wait
for wifi connecting，wifi icon on the screen will flickering during waiting.
Drain valve(Anti-frozen drainage)
If you don't use the heater for a long period, cut o the power by pressing the
power button and pull out the power supply plug.Close the water inlet and open the
drain valve to empty out the water inside ,then put the drain valve back.Maintain the
above condition until the next operation after drainage
Smart mode
Preset mode,the outlet hot water will change into recommended temperature
automatically according to the Inlet water temperature.Press the button again or
change setting button to exit mode
Inlet water Temperature°C Setting Temperature°C
40
16-21
≤15
42
46
≥28
22-27
44
To Next Page
Loading...
