21
APP function introduction
AP
distribution
network
BLE
distribution
network
on/o
Favorite
Setting
temperature
Add a device to configure the network:
Android mobile device;
Click Add Device in the upper right corner of the Mercure homepage;
Enter the correct wifi password in the home wifi information dialog (if
the home wifi has been entered, go directly to step 4);
Power on the device, turn it on, press and hold the Wi-Fi button for
more than three seconds, hear a long beep, and the Wi-Fi light flashes
rapidly;
Select the corresponding device in the device list (the first one is
selected by default),then connect it.
1.
2.
3.
4.
5.
Add a device to configure the network:
IOS mobile device;
Click Add Device in the upper right corner of the Mercure homepage;
Enter the correct wifi password in the home wifi information dialog (if
the home wifi has been entered, go directly to step 4);
Power on the device, turn it on, press and hold the Wi-Fi button for
more than three seconds, hear a long beep, and the Wi-Fi light flashes
rapidly;
Select the corresponding device in the device list,then connect it.
1.
2.
3.
4.
5.
Add a device to configure the network:
Android, IOS mobile devices;
Click Add Device in the upper right corner of the Mercure homepage;
Enter the correct wifi password in the home wifi information dialog (if
the home wifi has been entered, go directly to step 4);
Scan nearby devices to configure the network.
1.
2.
3.
4.
Click to switch the water heater
Smart Mode Smart Mode on/o(Click the smart Mode to enter the smart temperature
sensor mode and record the current set temperature)
Click the temperature plus or minus button (35°C-65°C)
Maximun
temperature
Maximum temperature mode on/o
kitchen
water
kitchen water on/o(Set the temperature to 38°C)
Regular
maintenance
maintenance call
Exclusive/exclusive temperature on/o
To Next Page
Loading...
