Midea WHT 4.60 IX

TROUBLE SHOOTING
Fault
Cause
Solution
Light on, but
motor does
not work
The blades are blocked.
The capacitor is damaged.
Replace capacitor.
The motor is damaged.
Replace motor.
The internal wiring of motor is
cut off/ disconnected. An
unpleasant smell
may be produced.
Replace motor.
Both light and
motor do not
work
Apart from the above mentioned, check the following:
Light damaged.
Replace lights.
Power cord loose.
Connect the wires as per the
electric diagram.
Oil leakage
Outlet and the air ventilation
entrance are not tightly sealed.
Take down the outlet and seal with
glue.
Leakage from the connection
of U-shaped section and cover.
Take U-shaped section down and
seal with soap or paint.
Vibration
The blade, if damaged, can
cause vibrating.
Replace the blade.
The motor is not tightly
fastened.
Fasten the motor tightly.
The cooker hood is not tightly
fixed.
Fixed the cooker hood tightly.
Insufficient
suction
The distance between the
cooker hood and the cooker
top is too large.
Readjust the distance.
Too much ventilation from
open doors or windows.
Choose a new place to install the
appliance or close some doors /
windows.
The machine
inclines
The fixing screws are not tight
enough.
Tighten the fixing screw and make
it horizontal.
The hanging screws are not
tight enough
Tighten the hanging screw and
make it horizontal.
DE
EN
12