In the encoder (Data) mode with CC (Relative) and CC (Absolute)
CC(Relative):0xBx (The encoder back to normal mode);
CC(Absolute):0xBx, Only the encoder (6.10), velocity bytes will enable the absolute value model,
each turn left, velocity bytes will start from 0x40 decreased ; Each turn right , velocity bytes will start
from 0x40 began to increase
6.18 Edit channel (CHANNEL)
Click on the "CHANNEL", the user can choose the encoder, potentiometers, buttons on the channel
(channel value is 0 ~ 15)
6.19 Edit button state (BUTTON)
This function only to walk with buttons (PLAY, STOP, REC), click on the "BUTTON" select LED
state
Toggle: In this mode, the LED is bright when press the button, put out when press the button again
Momentary: In this mode, the LED is bright when press the button, loosen the button is put out
6.20 Enable or disable (ENABLE)
The user can click on the "ENABLE" on the left side of the square, “√ “or cancel “√”
“√”: Enable the encoder or potentiometers, buttons state information, the AKM322 can send this
part of the information or light LED;
Cancel “√”: Disable these state
6.21 Data byte (VALUE)
User can click on the "VALUE" on the left side of the square space, fill in 0 ~ 127, such as the
currently selected edit encoder, the TYPE select NOTE, VULUE fill in 127, the synchronous data to
the AKM322, AKM322 sends a message format for the encoder (state bytes: 0x90, data bytes: 0x7f,
velocity bytes: 0 ~ 0x7f)
(7) Download AKM322 MIDI Editor software’s web:
Web: http://www.midiplus.com.tw/MIDIPLUS-Download.htm