34
Example 3: set right hand side keyboard program to be 002.
Operation:
(1) Press MIDI/SELECT button then release, the light on button on.
(2) Press key under【PROG】3 times then release, display show【 】,After 1s
display show latest setting of right hand side program such as【 】.
(3) Press key under 0~9,first【0】then【0】then【2】then release, display show
【 】,if not press key under 【CANCEL】then press again .
(4) Press key under【ENTER】then release, the light on MIDI/SELECT button off,
setting finished and keyboard return to play mode.
Remark: Right hand side program range 1~128 setting Invalid if value over this
range .
CURVE: Keyboard velocity curve setting
Example set keyboard velocity curve to be Curve 2 (there are 8 curves).
(1) Press MIDI/SELECT button then release, the light on button on .
(2) Press key under【CURVE】then release, display show latest setting such as
【 】.
(3) Press key under 0~9,first【0】then【2】then release, display show【 】,if
not press key under 【CANCEL】then press again.
(4) Press key under【ENTER】then release, the light on MIDI/SELECT button off,
setting finished and keyboard return to play mode.
Remark: There are 8 kind of velocity curve 1~8,setting Invalid if value over this
range .
CTRL ASSIGN: Sliders and knobs setting
Example: Assign volume to Master slider (control number 008).
(1) Press MIDI/SELECT button then release, the light on button on move Master
slider【S0】.
(2) Press key under【CTRL ASSIGN】then release, display show Master slider
number【 】, after 1s display show current setting of Master slider such as
【 】.
(3) Press key under 0~9,first【0】,【0】then【7】then release, display show【 】,if
not press key under 【CANCEL】then press again.
(4) Press key under【ENTER】then release, the light on MIDI/SELECT button off,
setting finished and keyboard return to play mode.
Remark: CTRL ASSIGN range 0~130,setting Invalid if value over this range, For
To Next Page
Loading...
Need help?
General
