3.6.1 Customizing The "T1 ~ T0" Knobs
To customize the knobs, follow these steps:
1. Press MIDI/SELECT button to enter Edit mode
2. Press “CTRL ASSIGN” key
3. Turn the knob you want to customize
4. Enter a value using the numeric keypad (value range between 0 to 127)
5. Press Enter key
5. Press MIDI/SELECT button to exit Edit mode
For example, to change the T1 knob to control the built-in tone’s “Chorus” effect. According to
5.5 MIDI CC (Continue Control) Map, the MIDI CC number of “Chorus” is “93” please follow these
steps:
1. Press MIDI/SELECT button to enter Edit mode
2. Press “CTRL ASSIGN” key
3. Turn the knob “T1”
4. Enter a value “93” using the numeric keypad
5. Press Enter key
6. Press MIDI/SELECT button to exit Edit mode
3.6.2 Customizing The "B1 ~ B8" Buttons
You can customize both modes of the buttons’ controls. In Program Change mode (except B7 and
B8), you can assign the button’s Program number, and in MIDI CC mode, you can assign the
button’s MIDI CC number. To customize the buttons, follow these steps:
1. Press MIDI/SELECT to enter Edit mode
2. Press “CTRL ASSIGN” key
3. Press the button you want to customize
4. Enter a value using the numeric keypad (value range between 0 to 9)
5. Press Enter key
6. Press MIDI/SELECT button to exit Edit mode
For example: assign the “B1” button as a shortcut to the “Church Organ” tone. First, make sure the
button is in Program Change mode (refer to 3.3 Changing The "B1 ~ B8" Buttons Mode for details).
According to 5.5 Instrument Patch Map, the number of “Church Organ” is “19”, please follow the
steps below:
1. Press MIDI/SELECT button to enter Edit mode
2. Press “CTRL ASSIGN” key
3. Turn the knob “B1”
4. Enter a value “19” using the numeric keypad
5. Press Enter key
6. Press MIDI/SELECT button to exit Edit mode
13
To Next Page
Loading...
Need help?
General
