Midland ALAN 95 D80 PLUS - Technical Specifications

Manual ALAN 95 D80 (neue Produktion), 09.11.2004, 15:51, Kirsten Kunter
TECHNICAL SPECIFICATIONS
Frequency range ......................................26.565-27.405 MHz.
Channels....................................................80 FM; 12 AM
Mode of operation......................................F3E (FM) A3E (AM)
Antenna impedance ..................................50 ohm.
Loudspeaker ..............................................8 ohm 0.5W.
Microphone................................................condenser type
Power supply .............................................10.9V/15.6V,nominal 13.8V (9
batteries 10.8 V).
Dimensions ................................................40x50x170 mm.
Weight .......................................................280GR. (without batteries).
RECEIVER
Sensitivity at 10dB S/N ..............................0.5µV (AM), 0.25µV (FM)
Selectivity...................................................6dB @ 5KHz
Squelch range............................................0.25V-500mV
Audio output power....................................0.5W @ 8 ohm (10% distortion)
Distortion at 1000 mV ...............................3%
Audio frequency response .........................400-2400 Hz
Intermediate frequency ..............................I° 10.695 MHz
II° 455 KHz
Spurious response.....................................more than 45 dB
Current drain at stanby ..............................80 mA when the save mode is off
...................................................................60 mA when the save mode is on
TRANSMITTER
RF Output Power .......................................4W AM 1W FM
Frequency Tolerance.................................0.005%
Harmonic Suppression...............................more than 70 dB
Current Drain .............................................900 mA
Modulation .................................................AM 90% (± 5%) ; FM dev. 2.0KHz
All specifications are subject to change without notice.