Midland BR200 - Transmitting and Receiving a Call; About Range; Monitor; Channel Selection

Model BR200
midlandusa.comPage 12
ABOUT RANGE
Your BR200 radio is designed to give you maximum range under optimum
conditions�
Optimum Conditions are:
•Openwarehousefloorplanorarea.
•Openruralareaswithoutobstructions.
• Flat areas where you can see the other person to ensure you get
maximum range�
• Be sure to use fresh or fully charged batteries - a low battery will
cause low power conditions�
TRANSMITTING AND RECEIVING A CALL
1� For maximum clarity, hold the radio at least 1 inch (2�5cm) from your
mouth�
2� Press and hold the PTT button and speak in a normal voice into the
microphone� The RX/TX LED will glow RED while transmitting�
3� To receive a call, release the PTT button� The RX/TX LED will glow
GREEN when your radio is receiving a transmission�
MONITOR
Pressing the Monitor button will let you hear noise so you can adjust the
volume level of the radio when not receiving a signal� This should be used
to check activity on your current channel before transmitting�
CHANNEL SELECTION
Rotate the Channel Selector knob to select one of the 16 channels�
SCAN FUNCTION
1� To begin scanning, press and hold the Scan Button for 3 seconds�
•Your radio will beep twice alerting you that the radio has entered
scan mode
2� When in Scan Mode, the radio will rapidly scan through all programmed
channels and will pause on any active channel�
Industrial Multi-Level
Inside Steel/ Concrete Industrial Building Inside Multi-Level Building
Up To 250,000 sg� ft� Up to 20 floors