Midland BTX2 Instruction Guide

UK
Midland BTX2 - 23
22 - Midland BTX2
UK
4. Press the “Rear” button until the red light indicator changes to a steady blue.
5. Now, press “Volume +” or “Volume -“ to increase or reduce sensitivity. Every
time you press the Volume buttons the RED light will ash for conrmation.
When you reach the end of the upper and lower limit, the RED light will not
ash.
6. Press again the “Backward” button; the Blue light will ash several times, in
order to let you know the selected sensitivity:
One ash = VOX disabled
Twice = very low sensitivity
3 times= low sensitivity
4 times= medium sensitivity (default setting)
5 times = high sensitivity
The light indicator is now back to steady RED (“Set up mode”) and the
changes are conrmed
7. If needed, you can adjust again the sensitivity repeating the steps from point
1, otherwise exit the Setting mode by double clicking the “Middle” button.
Once the red light turns o, the blue led starts blinking. Now you can use your
BTX2.
Disabling the VOX feature (Intercom and telephone)
Follow all the procedure described in the previous steps and choose the option of
only one ash (VOX disabled).
Wired connection always in background
This feature let you keep the wired connection always on, even when the phone
or the intercom is open. This feature can be useful when you connect a PMR446
transceiver.
By default this option is on.
Disabling:
› Enter the “Setup” mode:
› Turn o the unit
› Press and hold down the “Middle” button about 7 sec., until the Red light is
on permanently.
› Press the “Forward” and “Middle” button together for 3 seconds. The blue LED
will ash twice.
› Double click on the “Middle” button to exit the “Setup” mode and use the BTX2.
Enabling:
Follow the same procedure up described; now the blue LED will ash once.
To exit the “Setup” mode, double click the “Middle” button.
Setup and Firmware update
It is possible to congure and update the rmware of your BTX2 using the USB
connection to your PC. On the Midland web site www.midlandradio.eu in the
BTX2 page you can nd the PC software and the new rmware updates if avai-
lable.
ATTENTION DO NOT CONNNECT THE UNIT TO THE PC BEFORE you DOWNLOAD AND
INSTALL THE SOFTWARE
Use at your own risk
The use of the device will impair your ability to hear other sounds and others
around you.
Listening to music or speaking on a telephone may prevent you from hearing
others around you and distract you from riding safely. The use of such device
while riding may endanger you and others, and its use, in some areas, could not
be allowed.
Using this device at a high volume may result in permanent hearing loss.
If you experience ringing in your ear or any other hearing related pain, reduce the
volume or discontinue using this device. With continued use at high volume, your
ears may become accustomed to the sound level, which may result in permanent
damage to your hearing.
Please use this device at a safe volume level.
Warranty
This product is covered by European warranty rulings and should be returned to
the place where purchased for repair or replacement if not repairable. In the event
it that it is returned to us by your supplier then we will either repair or replace
within 15 working days from receipt.
European CE Notice Certification and Safety Approval
Information
This product is CE marked according to the RTTE Directive (99/5/EC) and is free
use in all the EU countries.
Users are not permitted to make any changes or modications to the device.
Modications which are not expressly approved by the producer invalidate the
warranty card.
For further information, please go to our website: www.cte.it

Midland BTX2 Specifications

General

FM radio	-
Headset mode	Yes
Maximum range	800 m
Channels quantity	- channels
Product color	Black
Protection features	Shock resistant, Water resistant
Quantity	2

Weight and Dimensions

Weight	- g