CT590S user’s manual | 17
Receiving CTCSS (R-CTCSS) - MENU No.11
As DCS codes, the CTCSS codes can be added to the channels for creating
new private channels.
Transmitting DCS - (T-DCS) - MENU No.12
In this Menu you activate DCS codes in tx mode. You can choose between
normal R-DCS (D023N-D754N) and inverted R-DCS (D023I-D754I)
Transmitting CTCSS (T-CTCSS) - MENU No.13
In this Menu you can set a CTCSS tone in tx mode.
You can choose: OFF or CTCSS (67.0 to 254.1 Hz)
Voice function (VOICE) - MENU No. 14
With this function, you activate a voice that informs you about any operation/
selection you are doing.
ANI-ID (ANI-ID) - MENU No.15
With this function you can set your ID-code. It can be programmed by the
proper programming software. You can edit up to 5 digits.
SCAN Resume Mode (SC-REV) - MENU No.16
Thanks to this function, CT590S can SCAN in frequency or channel mode.
You can choose amongst three options:
TO - Time-operated SCAN
Whenever a signal is detected, the radio will suspend the SCAN for 5 seconds,
and then will continue to SCAN even if the signal is still present.
CO: Carrier-operated SCAN
Whenever a signal is detected, the radio will stop scanning. It will resume to
SCAN once the signal will disappear.
SE: Search SCAN
The radio will stop scanning once a signal is detected.
To Next Page
Loading...
