CT590S user’s manual | 23
4. Press 1 on the main radio. The red led of the main radio and the green led of
the sub-radio will blink. ‘CL-OUT’ will appear on the display.
5. When the two leds do not blink anymore, the LCD of the main radio shows
‘COPING’ and the sub-radio reboots: this means that cloning is finished.
Before using the radios, turn them o and then on.
Memory/Frequency Mode conversion (VFO/MR)
To switch between memory and frequency mode push VFO/MR.
TX 1750Hz Call Tone
Press PTT + BAND to send 1750Hz call tone. This function is useful for com-
munications through repeaters.
TX/RX Reverse function (R)
The reverse frequency function interchanges the TX frequency with RX. This
function is very helpful when you operate with a repeater; you can check whe-
ther it is possible to receive the communication from the other part without
the use of the repeater.
Note: Briefly press * to enable/disable this function.
Frequency scanning
This function can scan the frequency.
1. In frequency mode , press * key for more than 2 seconds. The radio will start
scanning the frequency according to the set frequency step.
2. You can change the scanning direction with the ▲/▼ keys.
3. Press any key to stop the scanning.
Note: for Scan mode, see Menu No.16.
Channel scanning
This function can scan the channels.
1. In frequency mode, press * key for more than 2 seconds. The radio will start
scanning according to the channel you set.
2. You can change the scanning direction with the ▲/▼ keys.
3. Press any key to stop scanning.
Note: for Scan mode, see Menu No.16.
To Next Page
Loading...
