Midland G10 PRO User Manual

10 | Midland G10 PRO instruction guide
Troubleshooting
Problem Possible Cause Solution
The radio doesn’t
switch on
The battery pack is dischar-
ged and/or has not been
installed correctly.
Verify that the battery pack
is charged and that it has
been correctly installed.
The radio switches
o shortly after it has
been switched on
Discharged battery pack. Recharge the battery pack.
The battery pack does
not recharge
The battery-charger has not
been connected or installed
correctly.
Inspect the connections of
the battery-charger and the
installation of the batteries.
The radio switches
on but is unable to
receive signals
The site of installation is too
shielded.
Move to an another area.
The volume is too low Adjust the volume level.
Incorrect CTCSS or DCS
Check that the CTCSS
tone or DCS code corre-
sponds to the one set by the
parties you are communica-
ting with.
It is not possible to
communicate with
other parties
An incorrect radio channel
has been selected.
Select the same radio chan-
nel used by the parties you
are communicating with.
The radio is installed in a
shielded area or is too far
from the party you are
communicating with
Move to another area.
Incorrect CTCSS or DCS
Check that the CTCSS
tone or DCS code corre-
sponds to the one set by the
parties you are communica-
ting with.

Midland G10 PRO Specifications

General

Brand	Midland
Model	G10 PRO
Category	Transceiver
Language	English