Midland G15 - Troubleshooting

Midland G15 instruction guide | 
Troubleshooting
Problem Possible Cause Solution
The radio doesn’t
switch on
The battery pack is
discharged PShas not
been installed
correctly.
Verify that the battery
pack is charged and
that it has been cor-
rectly installed.
The radio switches off
TPPO after it has been
switched on
Discharged battery
pack.
Recharge the battery
pack.
The battery pack does
not recharge
Thebattery-charger
has not beenconnFDUF
edor installed correctly.
Inspect the connections
of the battery-charger
and the installation of
the batteries.
The radio switches on
but is unable to
receive signals
-PDBUJPO of USBOTNJTTJPO
is too shielded.
Move to an another
area.
The volume is too low Adjust the volume level.
Incorrect CTCSS or DCS
Check that the CTCSS
tone or DCS code cor-
responds to the one set
by the parties you are
communicating with.
It is not possible to
communicate
with other parties
An incorrect radio
channel has
been selected.
Select the same radio
channel used by the
parties you are commu-
nicating with.
The radio is installed in
a shielded area or is too
far from the party you
are communicating
with
Move to another area.
Incorrect CTCSS or DCS
Check that the CTCSS
tone or DCS code cor-
responds to the one set
by the parties you are
communicating with.