Midland G15 - Roger Beep (End Transmission Tone); Keypad Beep; VOX Function; Maintenance

 | Midland G15 instruction guide
The Battery power saving feature enables a reduction in consumption of up
to 50%. If it has been set, it automatically activates when the transceiver does
not receive any signalT for more than 5 seconds. Power savF can be disabled
through Programming software.
Roger Beep (End transmission tone)
When the PTT button is released, the radio will beep to confirm to other
usersUIBUZPVSUSBOTNJTTJPOIBTFOEFEBOETQFFDIDBOCFHJO
The Roger Beep can be enabled through the programming software.
Keypad Beep
If this function is active, you will hear a beep tone everytime you press
a button (It can be disabled through the programming software).
V09
The VOX feature enables hands free conversation without usingUIFPTTPG
BOPQUJPOBM709NJDSPQIPOF +ust speak in the direction of the microphone
and the communication will automatically activateThe VOX sensitivity can
be adjusted in 10 different levels (0,1,2,3…9) through the programming
software:
0 means that the VOX is turned off,Mevel 1 is set by default and has the
lowest VOX sensitivity, 9 is the highest one.
To activate the VOX feature, keep 'VODUJPOLFZpressed for about 4 sec.
With the programming software you can enable/disable the VOX feature
and select the sensitivity levels.
Maintenance
Your G15 JT designed to fulfill any TUBUVUPSZwarranty obligations and
to QSPWJEFNBOZZFBSTPGTFSWJDF
As JTUSVFGPS all electronic devices, we recommend GollowJOH thFsF few
suggestions: