Midland G15 instruction guide |
Whenever any signal is detected, scanning will stop on a busy channel
*f no GVODUJPOTBSFTFMFDUFE, TDBOwill start after 5 seconds.
If you press the PTT, the radio will transmit on the latest busy channel
"fter 10 seconds GSPN releasJOH the PTT, G15 will return UP the default
channel and scanning will be activeBHBJO.
Squelch
The Squelch function suppresses noises on free channels and allows receivJOH
PG even weak signals.
G15 has 10 different Squelch levels that can be set by programming software:
0 means that the Squelch is turned off-evel 1 to level 9 BMMPXT different levels
of noise reduction.
Make sure you do not set an excessively high squelch level because in this case
you may not be able to receive weaker signals. On the other hand an excessively
low Squelch value could enable the Squelch even when no signals are present.
Squelch must always be adjusted when no signals are present.
The Time Out 5imer is settable from 30 sec to 270 secthrough theQSPHSBNN
ing software.This feature is disabled by default.
Battery recharge
G15 is equipped for using a 74V Li-ion rechargeable battery pack which
can be charged CZ the DIBSHFSTVQQMJFE
It takes BQQSPYJNBUFMZ4 hours to fully recharge the radio. The -&% of the
desktop charger indicates the DIBSHFstatus:
Red = charging, Green = full charge
For maximum battery lifewe recommend charging the battery pack when
the G15 is off and the battery pack is fully discharged.
Using a different battery charger other than the one specified can cauTF
damage to your device or may even cause explosions and personal injuries.
To Next Page
Loading...
Need help?
General
