7
Make sure you do not set an excessively high squelch level as you may not be
able to receive weaker signals. On the other hand an excessively low Squelch
value could enable the Squelch even when no signals are present.
Squelch must always be adjusted when no signals are present.
Squelch
The Squelch function suppresses noises on free channels and allows to
receive even weak signals.
G18 has 10 (0-9) different Squelch levels that can be set by
programming software or the Menu:
0 means that the Squelch is turned off. Level 1 to level 9 will have
different levels of noise reduction. The higher the level, the louder the
Squelch will be.
By default, the Squelch level is set on level 5.
To select the Squelch level:
1. Press the MENU button;
2. Turn the Encoder knob until “SQL” is displayed;
3. Press the ENT button;
4. Turn the Encoder knob and select the desired Squelch level
(the levels available are 10);
5. Confirm your selection with ENT.
Battery recharge
G18 is equipped for using a 7.4V Li-ion rechargeable battery pack which
can be charged by the charger supplied.
It takes approximately 4 hours to fully recharge the radio. The LED of the desktop
charger indicates the charge status:
Red = charging, Green = full charge
For maximum battery life, we recommend charging the battery pack when the
G18 is off and the battery pack is fully discharged
Using a different battery charger other than the one specified can cause damage
to your device or may even cause explosions and personal injuries.
The Battery power saving feature enables a reduction in consumption of up to 50%.
If it has been set, it automatically activates when the transceiver does not receive
any signals for more than 5 seconds. Power save can be disabled.
To Next Page
Loading...
Need help?
General
