Midland G7 User Manual

18 | Midland G7 Pro user’s manual
MENU button
Channel selection
Press once the MENU button. The number of the channel will start flashing
on the display. Press the scroll buttons / to scroll up or down the PMR and
then LPD channels till you select the desired channel.
Press the PTT button to confirm, or wait for 10 seconds.
Refer to the table of frequencies.
CTCSS/DCS tones selection
Midland G7/G7E Pro can receive in two modes:
a. Open trac: in this case you will hear any communication transmitted on
the selected channel;
b. Group mode CTCSS/DCS: CTCSS/DCS tones are access keys that al-
low you to receive only messages coming from parties using the same
channel and code. The speaker will remain muted until the correct tone is
received.
To activate 1 of 38 dierent CTCSS/104 DCS tones in RX and TX
1. Turn on the radio.
2. Select the desired channel.
3. Press twice MENU until the Display shows oF.
4. By pushing the / controls the display will show CTCSS (ct blinking) or
DCS (dc blinking); press MENU to enter the CTCSS or DCS tones. Now
select the desired tone with the / keys.
5. To confirm the setting, press the PTT key or wait for approximately 10
seconds.

Midland G7 Specifications

General

VOX Function	Yes
Display	LCD
Operating Temperature	-20°C to +55°C
Frequency Range	446.00625 - 446.09375 MHz
Weight	123 grams (without batteries)
Power Supply	Battery or AC adapter